Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFAAC Keypad & Intercom Repair: The Mesquite Owner’s Guide
FAAC keypad and intercom repair in Mesquite usually runs $180 to $420 installed, depending on whether the keypad, the intercom, or the board behind them is the failed part. Most repairs are finished in one visit. We’re an independent service provider, not affiliated with FAAC, and we work on the brand across the valley, from Sun City to the older ranch homes off Riverside Road, where a driveway gate has to hold up through forty-mile-an-hour spring winds that pack sand into every seam and button on the post.

Owners usually find out the hard way. The code takes on the third or fourth try. The intercom crackles, then goes silent when a guest presses the call button. Sometimes the gate swings open fine but nobody can get the new code to register. That’s when the phone rings, and we’re on it.
Which FAAC Models This Applies To
FAAC keypads and intercoms show up across a range of the brand’s residential and light-commercial access controllers, and the replacement part is not universal. The faceplate on most units carries a model sticker. If the sun has baked it illegible – common on a Mesquite south-facing post – the size and wiring of the unit identify it. A single-gang keypad that shares a post with an intercom behind one plate is a different animal from a standalone reader, and the wiring count on the back tells us which generation we’re looking at.
That’s the compatibility trap: a keypad that fits one controller won’t always talk to another, even when the mounting looks identical. The pin count and the voltage the controller expects decide it.
On the OEM-versus-aftermarket question, we give homeowners the straight version. A genuine FAAC replacement matches the original exactly and keeps factory waterproofing intact. A quality aftermarket unit can cut the cost, but only if the wiring and voltage line up with your particular controller. We’ll quote both when both are viable and tell you which we’d choose for a Mesquite driveway. No part is stocked on a truck; we source the correct one for your unit and return to install it.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Signs Your FAAC Keypad & Intercom Repair Is Failing
The failure rarely hides. Here’s what we hear, and what it usually means:
- Code accepted only after several tries. The membrane buttons are worn or moisture has crept behind the keypad, so the contacts don’t register cleanly. In Mesquite’s heat, the keypad face ages faster than most owners expect.
- Buttons feel mushy or stick. That’s physical wear on the contact pad, often the first part to go on a keypad that’s been pushed every day for years.
- Intercom crackles or drops the call button. A failing speaker, microphone, or the wiring connection at the post, all of which sand and temperature swings work against.
- Gate works from the remote but not the keypad. The keypad or the access board it feeds has lost its link. Proves the operator is fine and points us straight at the access side.
- No power to the unit at all. A blown transformer, a tripped breaker, or a corroded splice. Worth checking, because this one is sometimes a simple fix, and sometimes it isn’t.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest range for Mesquite, parts and labor together:
- Keypad replacement, basic: $180 to $280 installed.
- Intercom repair or speaker/mic swap: $220 to $340 installed.
- Combined keypad and intercom unit, or access-board fault: $300 to $420 installed.
What drives the range is which part failed, whether the controller needs reprogramming afterward, and how the wiring at the post is holding up. We quote the price and agree it with you before a single bolt is turned. No surprises on the bill. Every job carries the 90-Day Done Right Promise in writing. You can also take $50 off any repair over $250, and seniors and veterans always get 5% off. Call (844) 797-2573 for a free estimate.
DIY or Call Us?
You can safely check a few things yourself. Look at the breaker and the low-voltage transformer feeding the unit. Look at the wiring at the post for corrosion or a loose splice. Write down the model number if you can read it.
Where DIY goes wrong is the access board and the wiring behind the keypad. Mixing up the connections or sending the wrong voltage into a controller can take out a board that costs more than the repair. This is low-voltage work, but there’s still current in there, and the controller is not a place to experiment. If a quick look doesn’t tell you the answer, it’s time to call. We answer the phone 24 hours a day, seven days a week, at (844) 797-2573, and we’ll tell you honestly whether it’s a repair or a replacement.
FAQs
Expect 8 to 12 years for a keypad and 10 to 15 for an intercom under normal use. Mesquite’s heat and sand shorten that, especially on a post that faces the afternoon sun. A unit that’s on its fourth failed button is usually ready to be replaced.
Sometimes, yes. A failed transformer, a corroded splice, or a programming fault is a repair, not a replacement. Worn membrane buttons or a dead intercom speaker usually call for a new unit. We’ll tell you which one you’re facing before any part is ordered.
Most keypad and intercom swaps are done in a single visit. A straightforward keypad replacement runs about an hour; a combined unit with reprogramming can take a little longer. We give you the window when we schedule, and we will be there when we say.
We identify your controller from the model sticker or, if it’s baked off, from the unit’s size and wiring. Then we match the keypad and intercom to that controller’s voltage and pin count, and quote OEM and quality aftermarket options where both work. The correct part is ordered for your unit, never assumed from a truck stock.
Written by the team at Ironworks Gate Co. Mesquite, serving Mesquite and nearby areas.